Owners manual

2007-09 VW Rabbit 2.5 w/out foglights

Installation Instructions

BX3826

Page 8 of 9 292-2963 11/26/08

27. On the passenger side of the fascia, remove

the plastic black webbing insert. Using a Phillips

screwdriver, remove the single screw holding the

webbing in place and set aside. Set webbing and

screw aside for later reinstallation.

30. Replace black plastic webbing as close to its

original position as possible. On the drivers side,

trim around the baseplate to make webbing ﬁ t

and snap back into place. The installation of the

baseplate is complete.

Install the tow bar and safety cables according to

the instructions when demonstrating this to the

customer. Be sure to include all the contents and

packages.

Do NOT substitute other devices if the tow bar pins

and clips are misplaced.

28. On the backside of the fascia, measure and mark 1”

to a 1 1/8” down to the crease in fascia existing loop

then trim. Do this to both sides. Reinstall fascia.

29. Replace black plastic webbing insert as close to

its original position as possible. On the passenger

side, trim around the baseplate to make insert

ﬁ t (white arrow). Replace the screw (gray arrow)

just below original location to hold the webbing in

place.

26. On the fascia, remove the black plastic webbing

insert on the drivers side. From the backside of the

fascia, remove the webbing by releasing the clip

(inset circle). This will be reinstalled later, set aside.

From front of fascia

From back of fascia