Owners manual
BX3786
2011-12 Toyota 4 Runner SR5
Installation Instructions
405-0216 Rev. B Page 7 of 9 1/26/12
14
14. Using a 13/32” drill bit and a large clamp,
clamp the top of the baseplate to the frame
rail. Then, using the baseplate as a template,
drill down into the frame rail through the top
back hole on each side. Secure the baseplate
with 3/8-16 x 1 1/4 hex bolts with 3/8” lock
washers and 1/4 x 1 x 1 nut plates. Make sure
that the baseplate is level, then tighten with
Loctite Red. Do this on both sides, then drill
out the top front hole and secure the baseplate
with 3/8-16 x 1 1/4 hex bolts with 3/8” lock
washers and a 1/4 x 1 x 1 nut plates. Do this
on both sides and tighten all bolts with Loctite
Red.
15. If necessary, use the 13/32” drill bit to clear
the remaining two holes in the sideplate.
Insert 3/8-16 x 1 1/2” hex bolts with 3/8” lock
washers and 1/4 x 1 x 1” nut plates. Do this
on both sides. Use Loctite Red on all bolts.
15
16
17
16. Using a utility knife, trim a rectangle from the
black deector 5 1/2” in from ush with the rst
large ridge in the back bottom corner. Do this
on both sides of the vehicle.
17. Reattach the black grill rail, front bumper and
black plastic deectors using the existing bolts
and push pins.
When using power drills be aware of the
dangers of torque and drill bit length.