Owners manual

BX3786
2011-12 Toyota 4 Runner SR5
Installation Instructions
405-0216 Rev. B Page 5 of 9 1/26/12
7. Using a at screwdriver, remove the push
pin connecting the plasic deector from the
driver’s side. Do this on both sides. Then
remove the white styrofoam bumper from the
front of the vehicle. Set all items aside to be
reinstalled later.
7
8
9C
8. Use a 14MM socket to remove three bolts
from the front bumper on each side of the
vehicle.
10A
10. Using a 12MM socket, remove the bolt for the
tubing bracket on each side of the vehicle (A).
Then, using two pairs of large vice grips, bend
the upper section of the bracket back and forth
to break the top sectoin of each bracket off
(B). The bolts and removed sections will not
be reinstalled.
9. Underneath the bumper, remove a 10MM bolt
with a 10MM socket from each side of the
vehicle (A and C). Remove the 10MM bolt in
the center (B). Remove bumper and set aside
with bolts to be reinstalled later.




9A
9B



10B

