Owners manual

BX3786
2011-12 Toyota 4 Runner SR5
Installation Instructions
405-0216 Rev. B Page 4 of 9 1/26/12
3. Using a 10MM socket, remove the bolt
from the center of the vehicle. Use a at
screwdriver to remove a push pin from
each side of the vehicle, located near each
headlight. Set push pins and bolt aside to be
reinstalled later.
3 4
5A
4. Using either a 10MM socket or a phillips
screwdriver, remove three screws located in
the driver’s side wheel well in front of the tire.
Do this on both sides. Set screws aside to be
reinstalled later.
6A
6. Remove the push pins from the back side
of the grill (A, white arrows). Use a 10MM
socket to remove the bolt from the center of
the grill (A, gray arrow). Once the grill is off,
locate the other two 10MM bolts located near
each headlight and remove them and the
black rail (B). Remove fascia and grill then set
push pins, bolts, fascia and grill aside to be
reinstalled later.
5. Starting in front of the driver’s side front tire
(5A), use a 10MM socket to remove the six
bolts from the underside (5B) of the fascia
following the front bumer to the passenger’s
side (5C). Unplug the running and fog lights
located in the center of the vehicle. Set bolts
aside to be reinstalled later.









5B


5C
 




6B