Owners manual

BX3783
2007-12 Toyota Yaris Liftback
Installation Instructions
405-0046 Rev G Page 9 of 12 9/10/12
22. Trim the plastic from in front of the fender
well, from the crease down 2” and over to
the ridge. Do this on both sides.
22


2”
21. Hold up the plate support and mark the
location. Trim the plastic. Do this on both
sides.

21

23. Temporally bolt tight the lower bracket to
the baseplate with just 3/8”-16 x 1” bolts
and 3/8”hex nuts only. Align the back of
the bracket holes to the center of the lower
frame webbing. Use as a template to drill
the back two holes with a 13/32” drill bit
(white arrows). Do this on both sides. On
the driver’s side only, use a 10MM socket
to remove the bolts (gray arrows) holding
the sensor so that it can be set out of the
way while drilling then replace.

23



24. Loosen the front two bolts (gray arrows).
Insert in the back 3/8”-16 x 1 1/2” bolts, the
spacer plates, 3/8” lock washers and 3/8”
hex nuts. Loctite Red all bolts and tighten.
Then install 3/8” lock washers onto the
front two (2) 3/8”-16 x 1” bolts (gray
arrows) and 3/8” hex nuts, Loctite Red all
bolts and tighten. Do this on both sides.


24

