Owners manual

BX3783
2007-12 Toyota Yaris Liftback
Installation Instructions
405-0046 Rev G Page 7 of 12 9/10/12
16. Pound in the protruding frame connector
so that it is level with both edges. Do
this on both sides of the vehicle.
2007-11 Models only
15. On the frame, use a reciprocating saw to
trim straight across under the little hump
and back to the groove then straight down.
Do this on both sides.


15
14. Measure up 2” on the edge of the
bumper core. Use a reciprocating saw to
cut ush with the bumper. Do this on both
sides.


14
12. Using a 14MM socket, remove four (4) bolts
from the frame extension, two on top and
two on the bottom. Do this on both sides.
Set extension and bolts aside for later
reinstallation.
 
 
12


13. Measure up 5/8” from the bottom and
across on the lower frame support
webbing. Use a reciprocating saw to cut
out the notch. Do this on both sides.
13
Using a good quality paint, spray cut edges
of frame to prevent rusting.

16