Owners manual

2009-13 Toyota Corolla
Installation Instructions
BX3781
405-0009 Rev. C Page 6 of 7 3/1/12
15.Attach baseplate safety cables as in above
photos or as close to as possible. If you are
unable to place safety cables in this location,
position the cables around a solid piece of the
frame. Do this on both sides.
15
BE SURE TO USE LOCTITE
®
RED ON ALL BOLTS
BEFORE TIGHTENING. TIGHTEN ALL BOLTS
ACCORDING TO THE TORQUE CHART ON THE
FRONT PAGE OF THESE INSTRUCTIONS OR ON
PAGE 3 OF THE BASEPLATE TOWING GENERAL
INSTRUCTIONS.
12

12. Insert 3/8-16 x 1 1/4” hex bolts with 3/8” lock
washers attached to 3/8-16 nut plates with
inserted into the frame rail on both sides to
hold the baseplate in place.
13. Using the baseplate as a template, drill both
holes in the under side of the frame rail with a
13/32” drill bit. Do this on both sides.
13


14


14. Insert 3/8-16 x 1 1/4” hex bolts and 3/8” lock
washers with 3/8-16 nut plates with inserted
into the frame rail. Use loctite on all the
bolts and tighten. Do this on both sides and
the bolts inserted previously. Reinstall the
bumper.


Install the tow bar and safety cables
according to the instructions provided in their
packages. When demonstrating this to the
customer, be sure to include all the contents
and packages.
Do NOT substitute other devices if the tow
bar pins and clips are misplaced.