Owners manual
2009-13 Toyota Corolla
Installation Instructions
BX3781
405-0009 Rev. C Page 4 of 7 3/1/12
5. Behind the fascia on the bottom of the bumper,
are two push pins to remove from the fascia’s
tabs. Remove with a at screw driver. Pull the
fascia forward on both sides and set aside for
later reinstallation.
7
7. Using a 14MM socket, remove the two bolts
on each side of the bumper and take the
bumper off. Set aside for later reinstallation.
5
6. Remove the styrofoam. On the driver’s side
only, using a at screw driver release the tabs
from the top of the bumper and tie the wire
loom up in the open area during baseplate
installation.
6
4
4. Just forward of the front tire underneath, using
a 10MM socket, remove the two metric bolts
(white arrows). Using a at screw driver,
remove the push pin (gray arrow). Do this on
both sides and set aside for later reinstallation.
3
3. Just forward the front tire on the upper corner
of the fascia and inside the wheel well, turn the
screw 90
o
to remove it (white arrow). Using a
at screw driver, remove the upper push pin
(gray arrow). Do this on both sides and set
aside for later reinstallation.