Owners manual

2009-13 Toyota Corolla

Installation Instructions

BX3781

405-0009 Rev. C Page 3 of 7 3/1/12

Vehicle Weight:

Motorhome mount tow bars are recommended for

use with this baseplate. Due to the design of the

removable tabs, the RangeFinderII, Adventurer, and

Ambassador tow bars can not be used. The Acclaim

tow bar may be used, but will not fold and store on the

front of the vehicle. Adapters, except the BX8833 and

BX88151, can not be used with this baseplate.

Tow Bar Adapters are NOT to be used with

vehicles weighing over 5,000 lbs.

Installation Notes: The fascia and

aluminum bumper and are removed and

reinstalled during installation of the baseplate.

Drilling is required. Trimming of the fascia is

required.

The dimensional variations between otherwise

identical vehicles can be considerable. While

the baseplate was designed for easy installation,

it may be necessary to tailor the baseplate

slightly to compensate for auto manufacturer’s

tolerances. These minor adjustments may include

ling a hole slightly, bending electrical rods and/

or bending end plates.

The BX8848 Bulb and Socket Wiring Kit is

recommended for this vehicle.

Installation Instructions:

1. Using the Phillips screw driver, remove the

Phillips screws (white arrow) from the top

corner edge of the fascia. Remove push pin

(gray arrow), do this to both sides and set

aside for later reinstallation.

2. Remove push pin from top edge of fascia

just below hood latch and set aside for

reinstallation later.

