Owners manual

7. Ahead of the front tire on the bottom edge of the fascia are two (2) bolts, remove these with

a 10MM socket. Unsnap well wheel liner from the lower fascia and pull forward. This will

allow room to drill. Using the upper holes on the baseplate as a template, drill two (2) holes

into the side of the frame rail with a 13/32" drill bit.

6. Tilt the back of the baseplate down, slide cross tube between the tie down loops and the

tab. Align the forward hole of the baseplate with the existing hole of the lower extension that

has the 7/8" O.D. spacer tube inserted. Place the 1/2" x 4" hex bolts through the outside of

the baseplate and hand tighten.

Insert the removable attachment tabs into baseplate, align tabs level with the vehicle, clamp

end plates to frame with vise grips and tighten 1/2" hex nuts on both sides. Be sure to use

Loctite® Red on all bolts prior to tightening. Tighten all bolts according to the torque chart.

BX3763

2005-2013 Toyota Tacoma

(Includes Prerunner)

Installation Instructions

292-2737 Rev. J Page 7 of 10 1/8/12