Owners manual

© 2003, 08, 11 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, Industrial
Park • Pender, Nebraska 68047 • Phone [phone] • Fax [phone] • www.blueox.com
TM
Page 2 of 4 292-2559 Rev. C 5/10/11
11. Set baseplate on top of frame ends and
clamp in place. Baseplate should be
fl at against the front of radiator support.
Using the baseplate as a template, drill
three holes with the 13/32" drill bit, both
sides.
8. Pinch clips together on the back of radiator
support and pull air dam forward, both sides
and set aside.
9. Make two short cuts in webbing using the hack
saw, on radiator support and bend out of the
way, both sides. Using the 1 1/4" hole saw, cut
holes in frame ends, both sides. Some models
may have a sensor on the driver's side webbing
to relocate.




7. Remove four metric bolts from headlight
assemblies, pull assembly forward, unplug
electrical connection, both sides and set aside.
10. Remove top metric bolt from harmonic
balancer on passenger's side, insert metric
bolt into the three 1/4" fl at washers and
reinstall to original position.




