Owners manual
405-0086 Rev E Page 5 of 9 9/6/12
BX3617
2011-13 Subaru Outback
Installation Instructions
9. In the middle under the vehicle, remove two push pins. The cover will now hang out of the way in order to get
the baseplate in underneath it. Set the push pins aside for later reinstallation.
10. Underneath the cover in order to remove the air dam, remove three push pins. One on each side and one in
the middle. Set the push pins aside for later reinstallation.
9
10
11. On the front of the air dam, remove three push pins one on each side and one in the middle. Set the push
pins aside for later reinstallation. The middle pin will not be reattached.
12. Relocate the temperature sensor to the backside of the bracket.
11
12
13A
13B
13. Using a 12MM socket, remove four metric bolts from the metal bumper, two on the top and two on the bottom.
Do this on both sides. Pull the bumper forward and set it and the bolts aside to be reinstalled later.