Owners manual

BX3616
2009-12 Subaru Forester
Installation Instructions
405-0010 Rev. E Page 4 of 8 3/13/12
4. Using a at screwdriver, remove six push pins
from up underneath. There is one in front of
the tire and two in the middle on both sides.
Pull fascia corners out to the side of vehicle,
then pull fascia forward and set it and push
pins aside carefully for later reinstallation.
3. Underneath in front of the tire, use a at screw
driver to remove the push pin in the corner.
Do this to both sides and set aside for later
reinstallation.
3
4A


4B

6. On the passenger side, also unplug the
christmas tree push pin.
5. On the driver’s side, with a 10MM socket
remove the bolt above the sensor. Set bolt
and sensor aside for later reinstallation.
Unplug the wire (gray arrow).

6

5




7


7. Using a 12MM socket, remove the four bolts
holding the bumper, two bolts on top and two
on the bottom. Do this on both sides. Set
bolts and bumper aside for later reinstallation.