Owners manual

BX3616
2009-12 Subaru Forester
Installation Instructions
405-0010 Rev. E Page 3 of 8 3/13/12
1. Using a at screwdriver remove the six push
pins from the at top edge of fascia. There are
three on each side. Set push pins aside to be
reinstalled later.
Vehicle Weight:
Motorhome mount tow bars are recommended
for use with this baseplate. Due to the design
of the removable tabs, the RangeFinder II and
Ambassador tow bars can not be used. Adapters,
except the BX8833 and the BX88151, can not be
used with this baseplate.
Installation Notes: The fascia is removed
and reinstalled during installation of the
baseplate. Drilling is required. Trimming of the
fascia and air dam is required.
The dimensional variations between otherwise
identical vehicles can be considerable. While
the baseplate was designed for easy installation,
it may be necessary to tailor the baseplate
slightly to compensate for auto manufacturer’s
tolerances. These minor adjustments may include
ling a hole slightly, bending electrical rods and/
or bending end plates.
For 2009-10 the BX8848 4-Diode Wiring Kit is
recommended.
For 2011-12 the BX8869 Tail Light Wiring Kit is
recommended.
Installation Instructions
1


2

2. Just forward the front tire, push the pin in the
center to release. Do this to both sides and
set aside for later reinstallation.

Handling of some cosmetic parts
when installing this product may
require the use of protective covers,
rags, specialty tools, etc. to prevent
damage.