Owners manual


TM
© 2007 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, Industrial Park
Pender, Nebraska 68047 • Phone [phone] • Fax [phone] • www.blueox.us
15. Using the 17/32" drill bit, drill out the existing
larger hole in frame rail, both sides.
16. Bend temperature bracket and sensor back
toward radiator. It may be necessary to bend
backet more when baseplate is installed and
may differ from vehicle to vehicle.
17. Hold baseplate to align with existing drilled
hole on frame, both sides and clamp to
frame with vise grips. Using the baseplate
as a template, drill a hole into frame with
the 17/32" drill bit, both sides. Insert
61-5288 into end of frame rail to align
with drill holes on driver's side, tighten
1/2" hex bolts and lock washers. Be sure
baseplate is level with vehicle. Insert
61-5289 into end of frame rail to align with
drill holes on passenger's side, tighten
1/2" hex bolts and lock washers. Be sure
and use loctite red on all bolts before
tightening. Torque all bolts according
to torque chart in General Instructions.
13. Using the 10MM socket, remove two metric
bolts from air bag sensor and carefully set out
of the way, both sides.
14. Using the fl at chiesel, remove the two weld
nuts inside frame rail, both sides. This will
allow enough room for nut plate on the inside
of frame.
Ô
Ô
Ô
Ô
Ô
Ô
Ô
Page 3 of 5 292-2636 8/5/08