Owners manual

2008-09 Saturn Astra

Installation Instructions

BX3333

Page 6 of 8 292-3038 Rev. B 7/30/10

13. On the passenger side, using a 25 Torx remove the

bolt. Then trim the plastic.

14. Cut straight across under the horn, making sure to

be level. Do this on both sides.

15. Using the hack saw blade, cut out the fascia middle

horizontal rib to the outside of the sensor. Remove

the whole piece to open the area up for baseplate

installation. Do this on both sides of the vehicle.

16. On the driver’s side only, install the bracket over the

top of the studs (white arrows). Tighten with a 3/8”

ﬂ at washer for the top stud, 3/8” lock washers and

8MM hex nuts. On the front (gray arrows), attach

3/8” ﬂ at washers, 3/8” lock washers and 8MM bolts

to the existing nuts.

17. Using the baseplate as a template, drill the two

additional holes on the side with the 13/32” drill bit.

Insert 3/8”x 1 1/4” hex bolts with Loctite Red into

the drilled holes, tighten with 3/8” lock washers and

3/8” hex nuts on the back side.

When using power drills be aware of the

dangers of torque and drill bit length.