Owners manual

Page 5 of 7 292-2932 Rev. D 5/27/11
2007-10 Saturn Outlook
Installation Instructions
BX3330
6. Using a 10MM socket, remove a bolt from the
brace for the fog light. In the picture above,
the bolt is hidden slightly (see white arrow).
Set bolt aside to be reinstalled later. Do this
to both sides of the vehicle. The fascia is then
ready to be removed from the vehicle and
carefully set aside to be reinstalled later.


6
6
7. Using a fl at screwdriver, remove pushpin (see
white arrow) and then using a utility knife , cut
along dashed line shown in the photo above
(see grey arrow). The plastic piece will not be
reinstalled and can be discarded. Do this to
both sides of the vehicle.




7
7
8. Mark and cut out frame according to the photo
above, using a reciprocating saw. Do this to
both sides of the vehicle.
8
8
9/16”
9/16”
1”
1”
2”
2”
3 3/4”
3 3/4”
9. Using a 15MM socket, remove two bolts from
the front of the bumper. Set bolts aside to be
reinstalled later. Do this to both sides of the
vehicle.


9
9


10. Drill a 1 1/4” hole into the frame, so the nut
plates can go through. Do this to both sides of
the vehicle.
10
10


When using power drills, be aware of the
dangers of torque and drill bit length.