Owners manual

Ô
Ô
12
12
Be sure that ALL electrical connections
are plugged in properly and functioning
BEFORE Installing the fascia.
11. Reinstall the horn bracket on the driver’s side.
Reinstall the metal bumper and styrofoam to their
original positions.
Ô
Ô
2005-07 Saturn Ion
Non Red Line
Installation Instructions
BX3325
11
11
The location for the BX8869
The location for the BX8869
Bulb and Socket Kit.
Bulb and Socket Kit.
Page 6 of 7 292-2677 Rev. D 6/8/09
12. Using the utility knife, cut 3/4” deep into the back
edge of the fascia to open the area for baseplate
installation. Do this to both sides of the vehicle.
NOTE: Some models may not need trimming of the
back fascia. Slide the fascia on the vehicle to verify.
Reinstall the fascia as close to the original position
as possible and trim the lower lip of the fascia’s
rib (12-A). It is not necessary to completely cut
out the horizontal rib. Be sure all of the electrical
connections are plugged in to their proper locations
for the horn (some models may have fog lights)
before installing the fascia.