Owners manual

BX2646
2013-14 Ford Fusion SE & Titanium Hybrid w/Adaptive Cruise
Installation Instructions
405-0346 Rev A Page 6 of 7 9/27/13
11. Using a 13/32” drill bit, drill the front top
hole thru the frame. Install a 3/8”-16 x
1” bolt, 3/8” lock washer and 3/8”-16
nut plate (white). Using a 13MM socket,
remove the existing frame nut and install
the side bracket with a 8MM at washer
and 8MM nut (gray). Install 3/8”-16 x
1-1/2” bolts, 3/8” lock & at washers and
3/8”-16 nuts into the lower holes (black)
with the spacer plate in between the
bracket and baseplate (inset). Do this on
both sides of the vehicle.
12. Using a 13/32” drill bit, drill the front holes
thru the metal brackets. Install 3/8”-16 x
1” bolts, 3/8” lock washers and 3/8”-16 nut
plates.





 
10. Using the existing hole, bolt the baseplate
to the frame with a 3/8”-16 x 1” bolt, 3/8”
lock washer and 3/8”-16 nut plate. Do this
on both sides of the vehicle. Level and
tighten down the baseplate.

9. Using a hammer, knock the edge of the
extension behind for baseplate clearance.
Do this on both sides of the vehicle.