Owners manual

BX2625

2011-13 Lincoln MKX (Limited Edition)

With Speed Control System

Installation Instructions

405-0150 Rev. E Page 6 of 9 1/26/12



14B

14A

BE SURE TO USE LOCTITE

RED ON ALL BOLTS

BEFORE TIGHTENING. TIGHTEN ALL BOLTS

ACCORDING TO THE TORQUE CHART ON THE

FRONT PAGE OF THESE INSTRUCTIONS OR ON

PAGE 3 OF THE BASEPLATE TOWING GENERAL

INSTRUCTIONS.

11. Using a 1 1/4” hole saw, drill two 1 1/4” holes into the frame, utilizing the two existing holes in the side of the

frame so an extension can be used to tighten up bolts. Do this to both sides of the vehicle.

12. Place baseplate on top of frame and line up the holes in the baseplate with the two existing holes on top of the

frame. Insert with Loctite the two existing 13MM bolts which were removed in step 6, to hold the baseplate into

place with the 13MM socket. Do this to both sides of the vehicle.

11B

11A



13. Align lower base plate holes to existing holes. They should meet but may need to be reamed out using the

13/32” and 17/32” drill bits. Do this to both sides of the vehicle.

14. Using the baseplate as a template, insert a 3/8-16x1” hex bolt, 3/8” lock washer and 3/8” at washer into the two

outside holes and tighten down with a 3/8” whiz nut w/14” wire (see white arrows). You will then insert a 1/2-

13x1” hex bolt, 1/2” lock washer and 1/2” at washer and tighten down with a 1/2” nut plate (see grey arrow).

Do this to both sides of the vehicle.

