Owners manual

BX2625

2011-13 Lincoln MKX (Limited Edition)

With Speed Control System

Installation Instructions

405-0150 Rev. E Page 4 of 9 1/26/12

3. Using a 5.5MM socket, remove two metric bolts from underneath the front edge of fascia. Do this to both sides of

the vehicle. Set bolts aside to be reinstalled later.

4. Then using a at screwdriver, remove three push pins that are located in the center of vehicle on the belly pan.

Set bolts and push pins aside to be reinstalled later. After all the bolts and push pins are removed, the corner of

fascia is then pulled out to the side and forward to remove. Set fascia aside carefully to be reinstalled later.



5. If vehicle is equipped with Speed Control, on the driver’s side only, using an 8mm socket remove two metric bolts

from the front of the cruise control box and one on the back side. Set bolts aside to be reinstalled later.

6. Using a 13MM socket, remove two metric bolts from the top of the metal bumper and one metric bolt from the

bottom (white arrows). Then using a 10MM socket, remove one metric bolt from the top and bottom of the

bumper (gray arrows). Do this to both sides of the vehicle.

