Owners manual

BX2617

2009-12 Lincoln MKS

2010-12 Lincoln MKT

Installation Instructions

405-0100 Rev. I Page 6 of 11 3/12/12

3. MKS models: On the underside use an 8MM socket to remove the bolts (white arrows). There is

one (1) bolt on the outermost edges of the fascia, gure 3C, one (1) directly in the center, gure

3A, and also one (1) between the push pins, gure 3B.

Remove the push pins (grey arrows) that are located on each side of the bolt, gure 3B with a at

screwdriver. Pull fascia corners out to the side of the vehicle, then pull forward.

Set fascia, bolts and screws aside carefully to be reinstalled later.

3. MKT models: In front

underneath, using a

5.5MM socket remove

seven bolts. Pull fascia

corners out to the side

of the vehicle, then pull

forward. Set fascia and

bolts aside carefully to be

reinstalled later.



3B 3A



3. MKT models: In front underneath, remove three push pins

from the center. Using a 5.5MM socket, remove one bolt on

each side (gray arrow). Pull fascia corners out to the side of

the vehicle to unsnap, then pull forward. Set fascia, pins and

bolts aside carefully to be reinstalled later.

