Owners manual

BX2607

2008-10 Mercury Sable

2008-09 Ford Taurus

Installation Instructions

405-0056 Rev. C Page 4 of 7 11/09/11

3. Using a Phillips screwdriver, remove two screws, located in front underneath on the driver’s side. On the

passenger side, remove the two screws and using an 8MM socket, remove one bolt. Set screws and bolt aside to

be reinstalled later.

4. Still underneath, remove the four push pins, two on each side, holding the plastic guard. Set guard and push pins

aside to be reinstalled later.



5. In front right under the opening, using an 8MM socket, remove the three bolts. Pull fascia corners out to the side

of vehicle, then pull forward. Set fascia and bolts aside carefully, to be reinstalled later.

6. On the passenger side in order to remove the washer reservoir, remove the two bolts from the left side using an

11MM socket. Set bolts aside to be reinstalled later.

7. Continuing with the washer reservoir, use an 8MM

socket to remove the top right metric bolt which

will not be reinstalled. Unplug everything and

completely remove. Then using a hack saw blade

trim the tab off. Set the washer reservoir aside to

be reinstalled.

