Owners manual

BX2528
2011 Mazda 2
Installation Instructions
405-0356 Page 5 of 7 9/5/13
5. Remove the temperature sensor from the
bumper and move it aside.
6. Using a 10MM socket, remove the ve
(5) screws from the lower shrouding. The
shrouding will not be reinstalled.
7. Using a 1/4” drill bit, drill a pilot hole as
shown in the bumper. Using a 1-1/4” hole
saw, drill out the pilot hole thru the bumper
and frame for nut plate access. Do this on
both sides of the vehicle.
8. Using a 13MM socket, remove the four (4)
screws from the lower frame extension.
There are two (2) on each side (white).
Using a reciprocating saw, cut two (2) slits
on the ange back to the face of the frame
(gray). Using vise-grips, bend the ange
down so it is ush with the face of the
frame (inset). Do this on both sides of the
vehicle.

 








