Owners manual

BX2528
2011 Mazda 2
Installation Instructions
405-0356 Page 4 of 7 9/5/13
1. Using a 10MM socket, remove the screw
from the top edge of the fascia (white).
Then remove the push pin (gray). Do this
on both sides of the vehicle.
2. Using a 8MM socket, remove the screw
from the edge of the wheel well. Do this
on both sides of the vehicle.
3. Using a 8MM socket, remove the six (6)
screws from the Underside of the fascia.
There are two (2) on each side (inset)
and two (2) in the middle. Pry the corners
of the fascia away from the vehicle.
Disconnect all electrical connections and
pull the fascia off from the vehicle.
4. Remove the push pin from the styrofoam
reinforcement. Do this on both sides of the
vehicle. Set the reinforcement aside.







