Owners manual

BX2410
2013 Dodge Dart SXT
Installation Instructions
405-0347 Rev A Page 5 of 7 1/28/14
5. Pull edges of fascia up and out to
separate from body. Repeat on other
side of vehicle. Then remove the fascia
from vehicle disconnecting any electrical
connections and set aside.
6. Remove the two (2) push pins from
the brace (gray). Using a 15MM socket
remove the three (3) bolts from brace
(white). Do this on both sides of vehicle.
Set aside the bolts for installation of
baseplate, the brace and push pins will
not be reused.
7. Trim the plastic shrouding in front of radiator on both sides of the vehicle approximately as
shown for clearance of the baseplate installation. Further trimming may be required until
baseplate clears the shroud.






