Owners manual

BX2407
2012-14 Dodge Challenger
Installation Instructions
405-0313 Rev A Page 7 of 9 9/3/13
12. Using a 10MM socket, remove the two (2)
screws from the bottom side of the washer
reservoir. Then remove the upper screw,
disconnect lines and set the reservoir
aside.
13. Using a reciprocating saw, notch the
frame end ush with the bottom of the
bumper and ush with the outside of
the frame. Do this on both sides of the
vehicle.
14. Measure back from the backside of the
frame end plate 7-1/8” and make a mark.
Do this on both sides of the vehicle.
15. Slide the baseplate onto the frame, line
the back of the baseplate with the mark.
On the driver side pin to the existing hole
in the frame (left). On the passenger side
install the washer reservoir bolt into the
existing hole (right). Level the baseplate
and clamp it to the frame.
 



