Owners manual
BX2407
2012-14 Dodge Challenger
Installation Instructions
405-0313 Rev A Page 5 of 9 9/3/13
5. Using a 7MM socket, remove the nine (9)
screws from the bottom edge of the fascia.
There are two (2) on each side and ve
(5) in the center.
6. Using a 10MM Socket, remove the two
(2) nuts from the fascia studs. One (1)
is located at on the top side above the
headlight (left) and the other in behind the
wheel well cover (right). Do this on both
sides of the vehicle. Remove the fascia
from the vehicle, unhooking any electrical
connections from the vehicle.
7. Remove the three (3) push pins from the
plastic fascia support and unsnap from the
metal bumper.
8. On the driver side, remove the two (2)
push pins from the plastic shrouding. Then
using a 7MM socket, remove the screw
from behind the air bafe. Set the air
bafe aside.