Owners manual
BX2407
2012-14 Dodge Challenger
Installation Instructions
405-0313 Rev A Page 2 of 9 9/3/13
Instruction Notes: The fascia, air bafe and windshield washer uid reservoir are removed and
reinstalled for the baseplate installation. Some drilling and trimming is required.
Place all components that are removed on a at, sturdy surface. All items will be reinstalled unless
otherwise noted after the baseplate is installed.
The dimensional variations between otherwise identical vehicles can be considerable. While the
baseplate was designed for easy installation, it may be necessary to tailor the baseplate slightly to
compensate for vehicle manufacturer’s tolerances.
The BX8869 Tail Light Wiring Kit is recommended for this vehicle.
Drill a hole according to the tail
light wiring kit instructions.
NOTICE
• Handling of some cosmetic parts when installing this product may require the use of protective
covers, rags, specialty tools, etc. to prevent damage.
• When using power drills be aware of the dangers of torque and drill bit length.
• When using a reciprocating saw be aware of objects behind the cutting surface.
• Use a good quality paint to spray cut edges of frame to prevent rusting.
• Be sure that ALL electrical connections are plugged in and accessories are functioning properly
before reinstalling the fascia.
• DO NOT use the towed vehicle for storing luggage, equipment, etc. The baseplate is computer
tested to your vehicle’s GVWR, exceeding this weight will void the manufacturer’s warranty.
• Be sure to use Loctite
®
Red on all bolts before tightening. Tighten all bolts according to the
torque chart provided.
• Dealer or installer be certain the user receives these instruction sheet.
• If the baseplate is in an accident, it must be replaced. DO NOT use it again! An accident can
cause unseen damage and using it again could result in more damage or serious injury. DO NOT
use the baseplate if it is damaged or missing parts.