Owners manual

BX2334
2012 Hyundai Veloster
Installation Instructions
405-0235 Page 6 of 9 1/11/12
PS
DS
DS
PS
8. Notch the bumper support tab at an angle to remove the outward protruding portion.
NOTE: Be careful not to notch the hook.
9. Ream out the existing two (2) holes on both side of the bumper using a 13/32” drill bit.
10. Once the baseplate has been installed, drill out the two (2) upright tubes that are located on
the front of the baseplate to 17/32”. Apply Loctite® Red prior to inserting the hardware.