Owners manual

4. Using a Phillips screwdriver, remove three
plastic Phillips push pins located in the middle
underneath. The fascia is then ready to be
removed from the vehicle. Set fascia and
push pins aside carefully to be reinstalled later.
2007-09 Hyundai Santa Fe
Installation Instructions
BX2324
6. Using a 10MM socket, remove one bolt and
release the clip from the wire harness, so it
can be moved out of the way. Do this to both
sides of the vehicle. Set bolts aside to be
reinstalled later.
Page 4 of 7 292-2946 Rev. C 6/15/10
5. Using a 10MM socket, remove two metric bolts
from the air baffl e located on the driver side of
the vehicle. Set air baffl e and bolts aside to be
reinstalled later.
7. Using a 10MM socket, remove two metric bolts
from the cooling condenser located on the
passenger side of the vehicle. Please discard
the bolts, because they will not be reinstalled
later.
Ô
Ô
Ô
Ô
Ô
Ô
4
4
Ô
Ô
6
6
Ô
Ô
7
7
Ô
Ô
8. On the passenger side, using a 10MM socket,
remove one metric bolt located underneath the
metal bumper on the passenger side of the
vehicle. Set bolt aside to be reinstalled later.
8
8
Ô
Ô
Ô
Ô
Ô
Ô
Ô
Ô
Ô
Ô
9
9
Ô
Ô
9. Using a 12MM socket, remove four metric
bolts from the metal bumper (see white
arrows) and then using a 10MM socket,
remove one metric bolt from the inside of the
metal bumper (see grey arrow). Do this to
both sides of the vehicle. Set metal bumper
and bolts aside to be reinstalled later.