Owners manual

1. Using a Phillips screwdriver, remove three
plastic Phillips push pins and then using a
10MM socket, remove one metric bolt. They
are all located on the top edge of the fascia on
the black plastic piece. Do this to both sides
of the vehicle. Set push pins and bolts aside
to be reinstalled later.
Vehicle Weight:
Due to the design of the removable tabs, the
RangeFinderII tow bar can not be used. Adapters,
except the BX8833 and BX88151, can not be
used with this baseplate.
Installation Notes: The fascia metal
bumper and air baffl e are removed and
reinstalled during installation of the baseplate.
Drilling is required. Trimming of the fascia is
required.
The dimensional variations between otherwise
identical vehicles can be considerable.
While the baseplate was designed for easy
installation, it may be necessary to tailor the
baseplate slightly to compensate for auto
manufacturer’s tolerances. These minor
adjustments may include fi ling a hole slightly,
bending electrical rods or bending end plates.
The BX8869 Bulb and Socket Wiring Kit is
recommended for this vehicle.
2007-09 Hyundai Santa Fe
Installation Instructions
BX2324
Installation Instructions:
Page 3 of 7 292-2946 Rev. C 6/15/10
2. Using a Phillips screwdriver, remove one
metric bolt just forward of the front tire, on
wheel well. Do this to both sides of the
vehicle. Set bolts aside to be reinstalled later.
1
1
Ô
Ô
Ô
Ô
Ô
Ô
Ô
Ô
Ô
Ô
2
2
3
3
3. Using a Phillips screwdriver, remove two
plastic Phillips push pins from just forward the
front tire underneath. Do this to both sides
of the vehicle. Set push pins aside to be
reinstalled later.
Ô
Ô
Ô
Ô
Ô
Ô
Possible Location of the BX8869
Possible Location of the BX8869
Bulb & Socket Wiring Kit
Bulb & Socket Wiring Kit
Handling of some cosmetic parts
when installing this product may
require the use of protective covers,
rags, specialty tools, etc. to prevent
damage.