Owners manual
BX2256
2012 Honda Civic (No Foglights)
Installation Instructions
405-0202 Rev. D Page 4 of 11 9/26/13
4
4
5
5
5. Just forward of the front tire, move the wheel well cover back. Using a Phillips screwdriver, remove the screw
from the corner of the fascia. Do this on both sides of the vehicle. Set screws aside to be reinstalled later.
6. Lift and pull up on the outside corner of the fascia next to the wheel to release the tabs. Do this on both sides.
Set fascia aside carefully to be reinstalled later.
3. Underneath the fascia in the corner in front of the tire, remove one push pin. Do this on both sides of the
vehicle. Set push pins aside to be reinstalled later.
4. Along the bottom edge of the fascia, remove fi ve push pins. Do this on both sides of the vehicle. Set push
pins aside to be reinstalled later.
3
3
6
6
7
7
8
8
7. On the driver side, using a 10MM socket, remove the metric bolt from the top of the air baffl e. Set air baffl e
and bolt aside to be reinstalled later.
8. On the passenger side, remove the push pin on the top of the washer reservoir by the motor. Set push pin
aside to be reinstalled later.