Owners manual
2008-10 Honda Odyssey
2009-12 Honda Pilot EXL
Installation Instructions
BX2251
26
26. Reinstall the air bafe. Snap everything back together. Using a 10MM socket, reinstall the three bolts on the
side, back and top.
27. Reinstall the headlight assembly. Using a 10MM socket, reinstall the four bolts on the top, side and front.
Also reinstall the pushpin on the top.
27
29
28. Attach the coolant line to the extensions using 1/4-20 x 3/4” bolts and 1/4-20 whiz nuts (white arrow). Do this
on both sides. Attach the temperature sensor to the bracket with a cable tie.
29. Attach the permanent baseplate safety cables to the provided convenience link on the baseplate (see gray
arrow). The photo above shows the recommended installation of the cables to frame of vehicle (see white
arrow). Additional options may interfere with suggested mounting; in this case secure the cables to a solid
piece of the frame as described in the instructions included with the permanent baseplate safety cables. Be
sure the safety cables do not rub against any hoses or moving parts. Do this to both sides of the vehicle.
28
30
30. Cut out the rst vertical style from the end on each
side of the front fascia.
31. Reinstall the fascia, bolts and push pins.
Install the tow bar and safety cables according to
the instructions included in their packages.
Do not substitute other devices if the tow bar pin
and clip are lost.
Be sure that ALL electrical connections
are plugged in properly and functioning
BEFORE Installing the fascia.
Page 9 of 10 405-0096 Rev D 10/14/11