Owners manual

2008-10 Honda Odyssey
2009-12 Honda Pilot EXL
Installation Instructions
BX2251
17
17. On the passenger side, remove the push pin by the washer reservoir ll lid. Set aside to be reinstalled later.
18. Using the 10MM socket, remove one bolt from the side of the washer reservoir. Set the bolt aside to be
reinstalled later.
18



20
19. Using the 10MM socket, remove one bolt from the bottom of the washer reservoir. Set the bolt aside to be
reinstalled later and move the washer reservoir out of the way.
20. Cut on the top edge of the frame front webbing and 1/2” above the frame with the reciprocating saw. Be
careful not to cut into coolant lines, radiator or electrical wiring. Bend the webbing toward the headlight area.
Do this to both sides of the vehicle. This will open the area for the baseplate installation.
19


21. Clamp the baseplate on as far back as it will go. It
will hit the rib on the bottom of the radiator cross
member. Mark the areas affecting the baseplate
(see step 22) then remove the baseplate.
21

Page 7 of 10 405-0096 Rev D 10/14/11