Owners manual

Page 4 of 8 405-0043 Rev. B 7/27/10

2008-10 Honda Accord

Installation Instructions

BX2249

6. On the driver’s side, use a 10MM socket to remove

the two bolts holding the air bafﬂ e. Don’t remove

the air bafﬂ e just pull it back out of the way. Set the

bolts aside to be reinstalled later.

4. Pull the fascia out up to the blinker. Use a small

ﬂ at screw driver to pry down on each clip in the

series of four in order to release the fascia. Pull

the two eyelets up off the pins. Do this on both

sides. Slide the fascia off, disconnect fog lights

and set aside carefully to be reinstalled later.

6. On the driver’s side, remove the push pin just

forward of the front tire in the wheel well. Set the

push pin aside to be reinstalled later.

3. Underneath the fascia, remove ten push pins

all the way around. Set push pins aside to be

reinstalled later.