Owners manual

BX2246
2007-11 Honda CR-V
Installation Instructions
292-2906 Rev. H Page 5 of 10 8/9/11
7. Using the 10mm socket, remove one metric
bolt from the coolant line bracket at the bottom
of radiator. Set bolt aside to be reinstalled
later.
7
8
9
8. On driver’s side, remove the coolant line clip
from the front of lower frame support just
below metal bumper. Do not remove clip
from coolant line. Pull the driver’s side end
of coolant line over to the passenger side of
vehicle to clear area for baseplate installation.
10
10. Using the reciprocating saw, cut the metal
bumper to make it ush with the side of the
frame rail, approximately 1/4” from the end
of metal bumper. Do this to both sides of the
vehicle. This clears the area for baseplate
installation.
9. Using the reciprocation saw, cut through
the webbing of the frame end – making a
horizontal cut even with the top edge of frame
rail end (see white arrow) starting from the
outer edge of webbing and ending ush with
the side of frame. Then make a vertical cut
starting from the bottom of frame webbing,
ush with the side of frame, up to the end of
initial cut and remove this portion of webbing.
Next make two horizontal cuts on the frame
support webbing (see grey arrows) and atten
with the hammer. Do this to both sides of the
vehicle.




