Owners manual

BX2246
2007-11 Honda CR-V
Installation Instructions
292-2906 Rev. H Page 4 of 10 8/9/11
3. On driver’s side, remove one metric bolt
from the lower edge of fascia, just forward of
front tire, using the 10mm socket. Do this to
both sides of vehicle. Set bolts aside to be
reinstalled later.
3 4
5
4. Remove four pushpins from the bottom of
fascia. Pull fascia corners to the side, then
forward to remove. Set pushpins and fascia
aside carefully to be reinstalled later.
6
6. On passenger’s side, on coolant line closest
to washer reservoir, remove one metric bolt
using the 10mm socket (see lower white
arrow) and disconnect one clip from line (see
upper white arrow). On the coolant line closest
to frame, disconnect two clips (see grey
arrows). The two upper clips will remain on
vehicle and the two lower clips are to remain
on coolant lines.
5. On the driver’s side, remove two metric bolts
from the air bafe using the 10mm socket. Pull
air bafe down and out to the side of vehicle
to remove. Set bolts and air bafe aside to be
reinstalled later.










