Owners manual
BX2246
2007-11 Honda CR-V
Installation Instructions
292-2906 Rev. H Page 3 of 10 8/9/11
Attachment Tabs: Motorhome mount
tow bars are recommended for use with this
baseplate. Due to the design of the removable
tabs, the RangeFinderII and Ambassador tow
bars can not be used. The Acclaim tow bar may
be used, but will not fold and store on the front
of the vehicle. Adapters, except the BX8833 and
BX88151, can not be used with this baseplate.
Installation Notes: The fascia, air bafe,
metal bumper, temperature sensor and washer
reservoir are removed for installation. Trimming
is required. Drilling is required.
The dimensional variations between otherwise
identical vehicles can be considerable. While
the baseplate was designed for easy installation,
it may be necessary to tailor the baseplate
slightly to compensate for auto manufacturer’s
tolerances. These minor adjustments may
include ling a hole slightly, bending electrical
rods or bending end plates.
The BX8869 Bulb and Socket Wiring Kit is
recommended for this vehicle.
1. Remove seven pushpins from the top of the
radiator cover. Pull radiator cover forward to
remove. Set radiator cover and pushpins
aside to be reinstalled later.
Installation Instructions:
1
2
2. Just forward of front tire, inside the wheel well,
remove two Phillips screws (see white arrows).
Remove one pushpin on the corner of fascia,
just above the upper Phillips screw (see grey
arrow). Do this to both sides of the vehicle. Set
screws and pushpins aside to be reinstalled
later.
Handling of some cosmetic parts when
installing this product may require the use of
protective covers, rags, specialty tools, etc.
to prevent damage.
Possible location for the BX8869 Bulb and
Socket Wiring Kit.