Owners manual

2006-11 Honda Civic
(Incl. EX, LX, DX)
Installation Instructions
BX2243
24. Slide the baseplate endplate to the outside of the
support plate and align with the existing four holes
of the support plate. Ensure baseplate is level with
the vehicle and tighten all bolts.
NOTE: not every bolt hole may align properly.
Insert the bolts to the holes that are aligned
properly fi rst. Then, ream out remaining bolt holes
with 13/32” drill bit and insert bolts.
24
24
25. Place the windshield washer back to its original
position on the passenger’s side. Insert the 6MM-
1.0 x 30MM hex bolt and fasten with the ¼” fl at
washer and ¼” lock washer (A in photo above).
Insert and tighten original metric bolt removed
earlier (hidden behind hoses in photo above - B).
Insert 6MM-1.0 x 45MM hex bolt and fasten with
the ¼” fl at washer and ¼” lock washer using the
3/8” pipe spacer between the washer reservoir
and the existing location on the frame. (C in photo
above).
25
25
A
A
C
C
B
B
26. On the backside of the fascia, using a utility knife,
cut an opening to allow for the fog lights when
reinstalling the front fascia. Make a vertical cut
of one inch. Make two horizontal cuts (shown) of
approximately two inches. Do this to both ends of
the fascia.
26
26
Page 9 of 10 292-2797 Rev. H 5/25/11
27. Align the fascia to its original position and, using
a hack saw blade, trim necessary openings in the
grille for the attachment tabs and convenience
links.
27
27
28. Reinstall the bumper, air baffl e, and fascia inserting
all push pins, screws, and bolts. The installation of
the baseplate is now complete.
28. Attach the permanent baseplate safety cables to
the provided convenience link on the baseplate.
Secure the cables to a solid piece of the frame. Do
this to both sides of the vehicle.