Owners manual

2002-04 Honda CR-V
2003-11 Honda Element
Installation Instructions
BX2232
Page 6 of 7 292-2558 Rev. I 07/11
10. Insert the nut plate with wire into the opening
in the frame end to align with the three upper
drilled holes. Tighten the 3/8-16x1 1/2” bolt
and lock washer. Do this to both sides of the
vehicle.
10
11. Install the 3/8-16x1” bolt into the lower drilled
holes in the webbing, tighten hex and lock
washer. Do this to both sides of the vehicle.
11
DEALER or INSTALLER:
Be certain the user receives the
instruction sheets for their products.

12. Attach the permanent baseplate safety
cables to the provided convenience link on
the baseplate (see grey arrow). The photo
above shows the recommended installation
of the cables to frame of vehicle (see white
arrow). Additional options may interfere with
suggested mounting; in this case secure
the cables to a solid piece of the frame as
described in the instructions included with the
permanent baseplate safety cables. Be sure
the safety cables do not rub against any hoses
or moving parts. Do this to both sides of the
vehicle.
12


Be sure that ALL electrical connections
are plugged in properly and functioning
BEFORE installing the fascia.
13. Reinstall the fascia and use the two backing
plates on the lower push pins that were
removed in step 4. Some models may require
minor trimming to back side of the fascia.
Install the tow bar and safety cables according
to the instructions included in their packages.
Do NOT substitute other devices if the tow bar
pin and clip are lost.