Owners manual

15. On the passenger side, do the same thing
but there is an extra hole to reinstall the
windshield washer tank in that hole use the
longer 6MM bolt.
16 Trim the air dam, from the to edge take off 2
3/4”. This allows clearance for the baseplate.
Page 7 of 8 292-3000 Rev. D 8/31/10
16
16
Ô
Ô
2008-11 Ford Focus SES (Manual Transmission)
Installation Instructions
BX2199
15
15
Ô
Ô
Ô
Ô
17. Attach the permanent baseplate safety
cables to the provided convenience link on
the baseplate (see grey arrow). The photo
above shows the recommended installation
of the cables to frame of vehicle (see white
arrow). Additional options may interfere with
suggested mounting; in this case secure
the cables to a solid piece of the frame as
described in the instructions included with the
permanent baseplate safety cables. Be sure
the safety cables do not rub against any hoses
or moving parts. Do this to both sides of the
vehicle.
17
17
Ô
Ô
22. Reinstall air dams, fascia, headlights, grille
assembly, radiator cover, pushpins, bolts and
screws. Note: Air dams may be left off vehicle
or hold air dams just below original location
and mark and trim the air dams to allow
baseplate to fi t.
Install the tow bar and safety cables
according to the instructions provided in their
packages. When demonstrating this to the
customer, be sure to include all the contents
and packages.
Do NOT substitute other devices if the tow
bar pins and clips are misplaced.
Be sure that ALL electrical connections
are plugged in properly and functioning
BEFORE installing the fascia.