Owners manual
14 Using the 6mm socket, loosen the air bafe clamp.
Disconnect electrical connection. Pull air bafe
down and set aside.
14
15. Follow the air dam plastic (shown in photo)
to above the metal bumper and use the at
screwdriver to remove two pushpins. Pull air dam
forward to remove. Do this to both sides of the
vehicle. Set air dams and pushpins aside to be
reinstalled later.
15
16. Slide the baseplate onto the frame rails 1 1/2” back
from the bumper bracket aligning the front air bafe
hole with the front middle hole of the baseplate.
Align the top edge of the endplate with the top
edge of the frame rail and clamp in place using the
large vise grips. Hold the fascia up to its original
position and verify the convenience links, electrical
rods and attachment tabs come through the fascia
opening.
16
17. Using the baseplate as a template, drill four corner
holes into the frame webbing with the 13/32” drill
bit. Insert 3/8”-16 x 1 1/4” hex bolts into holes and
tighten to the 1/4” lock washers and 3/8-16 hex
nuts.
17
When using power drills be aware
of the dangers of torque and drill bit
length.
Page 7 of 9 292-2864 Rev D 08/18/11
2005-07 Ford Focus (Includes Foglights)
Installation Instructions
BX2184