Owners manual

BX1987
2008-13 Smart Car
(with fog lights)
Installation Instructions
405-0050 Rev. E Page 7 of 13 4/9/12

15. Remove push pin from the top of the wheel
well. Do this on both sides. Set aside to be
reinstalled later.
NOTE: This step is not necessary on 2012
models.
16. Using the 10MM socket, remove the bolt on the
bottom. Do this on both sides. Set aside to be
reinstalled later.
NOTE: This step is not necessary on 2012
models.

17. Remove the push pin on the right side. Do this
on both sides. Fasten the wheel well covers
out of the way and set the push pins aside to
be reinstalled later.
NOTE: This step is not necessary on 2012
models.

18. Using the 25 Torx, remove the bolt from the
air temperature sensor on the back side of
the metal bumper. Also, remove the push pin
beside it (grey arrow). Do this on both sides.
Set the bolt and push pin to be reinstalled
later.
NOTE: This step is not necessary on 2012
models.

