Owners manual

4. Using a 18MM socket, remove three metric
nuts from the metal bumper. Set bumper and
nuts aside to be reinstalled later. Do this to
both sides of the vehicle. Some models may
have a tow hook that will need to be removed,
if applicable.
2007-09 Chrysler Aspen
2007-09 Dodge Durango
Installation Instructions
BX1977
Page 4 of 6 292-2937 12/3/08
5. Lift baseplate straight up and slide forward
up to dimple in frame. Baseplate should be
straight and clamped into place with vise grips.
3. Using a 10MM socket, remove one metric
bolt located on the side of the opening in the
fascia. Set bolt aside to be reinstalled later.
Do this to both sides of the vehicle.
3
3
Ô
Ô
Ô
Ô
4
4
Ô
Ô
Ô
Ô
5
5
6. Using the baseplate as a template, drill two
holes into the side of the frame and one hole
in the bottom of the frame with a 17/32” drill
bit. Place a piece of tubing over drill bit for
protection while drilling out holes. Insert the
1/2” nut plates into the frame and align with
drilled holes. Insert a 1/2-13X1 1/2” hex
bolt and 1/2” lock washer into each hole and
tighten down with a 3/4” socket. Do this to
both sides of the vehicle.
6
6