Owners manual

1. Using a 10MM socket, remove three metric
bolts just forward the front tire, on the wheel
well. Once bolts are removed from the wheel
well, pull plastic back and remove two metric
bolts with a 10MM socket. Set bolts aside to
be reinstalled later. Do this to both sides of
the vehicle.
Vehicle Weight:
The weight of this vehicle is near the Class
III, 5,000 lb. rating limitations. Some models,
depending on options, may well exceed this
5,000 lb. rating. Be sure to confi rm the weight of
your individual vehicle before towing. As of 1999,
the Aventa
®
II is now 10,000 lbs. and either
the Aventa
®
II or the Aventa
®
LX tow bar must be
used for these applications.
Tow Bar Adapters are NOT to be used with
vehicles weighing over 5,000 lbs.
Installation Notes: The fascia and
metal bumper are removed and reinstalled
during installation of the baseplate. Drilling is
required. Trimming of the fascia is required.
The dimensional variations between otherwise
identical vehicles can be considerable.
While the baseplate was designed for easy
installation, it may be necessary to tailor the
baseplate slightly to compensate for auto
manufacturer’s tolerances. These minor
adjustments may include fi ling a hole slightly,
bending electrical rods and/ or bending end
plates.
The BX8869 Bulb and Socket Wiring Kit is
recommended for this vehicle.
2007-09 Chrysler Aspen
2007-09 Dodge Durango
Installation Instructions
BX1977
Installation Instructions:
Page 3 of 6 292-2937 12/3/08
Ô
Ô
Ô
Ô
Ô
Ô
1
1
Ô
Ô
2
2
2. Using a 10MM socket, remove one metric bolt
from the front of the fascia. Set bolt aside to
be reinstalled later. Do this to both sides of
the vehicle.
Ô
Ô
Location for the BX8869
Location for the BX8869
Bulb and Socket Wiring Kit.
Bulb and Socket Wiring Kit.