Owners manual

BX1849
2013-14 Nissan Sentra S/SV/SR/SL
Installation Instructions
405-0338 Page 5 of 8 7/2/13
5. Pull the corners of the fascia out and
forward to unclip. Remove the fascia from
the vehicle and set aside.
6. Pull the styrofoam support off the metal
bumper.
7. Trim the plastic shrouding approximately
as shown for baseplate clearance. Do this
on both sides of the vehicle.
8. On the ller tube of the washer reservoir,
remove the push pin by the ller cap (top
left). Using a 10MM socket, remove the
screws from the top (top right) and bottom
(bottom right) of the reservoir. Disconnect
electrical lines and plug uid lines. Set the
washer reservoir aside.




