Owners manual

BX1849
2013-14 Nissan Sentra S/SV/SR/SL
Installation Instructions
405-0338 Page 4 of 8 7/2/13
1. Using a 10MM socket, remove the two (2)
bolts from the top edge of the fascia cover
(gray). Then remove the fourteen (14)
push pins from the cover (white). Set the
cover aside.
2. Remove the four (4) push pins from the
top edge of the fascia. There are two (2)
on each side.
3. Using a 10MM socket, remove the bolt
from behind the wheel well cover where
the fascia meets the fender. Do this on
both sides of the vehicle.
4. From the bottom edge of the fascia, using
a 10MM socket, remove three (3) bolts
(white). Then remove three (3) push
pins (gray). Do this on both sides of the
vehicle.
























