Owners manual
BX1842
2008-12 Nissan Innity G37S
Installation Instructions
292-3023 Rev. A Page 7 of 9 6/1/12
17. Install into the three drilled holes, two on the side and one on the bottom, 3/8-16 x 1 1/2” hex bolts and
3/8” lock washers with 61-5208 nut plates inserted into the frame end (photo 17B, gray arrow). Use
Loctite Red on all the bolts and tighten. Do to both sides of the vehicle.
17A
18. Pop off the plastic piece from the back of the bumper (photo 18A). Mount it to the bracket shown in
photo 18B.
18A 18B
17B
BE SURE TO USE LOCTITE
®
RED ON ALL BOLTS
BEFORE TIGHTENING. TIGHTEN ALL BOLTS
ACCORDING TO THE TORQUE CHART ON THE
FRONT PAGE OF THESE INSTRUCTIONS OR ON
PAGE 3 OF THE BASEPLATE TOWING GENERAL
INSTRUCTIONS.