Owners manual

BX1842
2008-12 Nissan Innity G37S
Installation Instructions
292-3023 Rev. A Page 4 of 9 6/1/12
7. To remove the aluminum bumper, remove
four (4) bolts, two (2) on the top and two (2)
on the bottom using a 12MM socket. Do this
to both sides. Unfasten all clips. Pull bumper
forward. Set aside bumper and bolts for later
reinstallation.
7

5

5. In the wheel well, just forward the front tire,
remove one (1) push pin. Do this on both
sides and set aside for later reinstallation.
4. Using a 10MM socket remove three (3) more
bolts underneath the fascia in front of the tire.
Do this on both sides. Set both aside for later
reinstallation.

4


6

6. Pry out the wheel well cover. Use a 10MM
socket to remove bolt forward of the front tire.
Do this to both sides of the vehicle. Set bolt
aside to be reinstalled later. Pull the fascia
corners out to the side of the vehicle, both
sides, then pull fascia forward and carefully set
aside for later reinstallation.
3. Underneath the fascia remove the ten (10)
bolts all the way across the bottom (driver’s
side shown) using a 10MM socket Set bolts
aside for later reinstallation
3






